OverLapF v1.0d
This program combines lines that partially overlap so that 2 line
entities become 1 line entity. You have the option to combine the overlapping lines
or mark them with an ellipse. Updated! The ellipse
covers the overlap only, not the ends of the two lines that create the overlap.
Screen Shot:
About:
OverLapF v1.0 Copyright 2003 John Leavines. All rights reserved.
This application finds overlapping lines in Autocad drawings.
Note: Create a backup copy of drawings before running this application.
It changes the endpoints of the longer of the 2 lines so that it extends the entire length
previously covered by 2 lines.
It deletes the unused line from the drawing. If 2 lines meet at one common endpoint it
does not change them.
If user picks Same Color or Same Layer or Same Linetype on the form the application will
not change the lines unless they are the same color, or layer or linetype.
The application works on 'LINE' entities only.
Lines are changed on the X & Y coordinate. This application is not meant to manipulate
or preserve the Z coordinate on the lines it changes. It is intended for manipulation of 2
dimensional lines only. If a line has a Z coordinate that is not equal to 0 then it will
not be changed.
Use the "Just draw ellipse" checkbox to draw an ellipse around the overlapping
lines. The program still filters per the other selections on the form. The
ellipse will cover the overlap only. Not the ends of the lines creating the overlap.
The ellipses are put on a layer called OverLapF in color cyan.
The application creates a log file called OverLapF.log. It contains the entity list of all
the lines that were changed or encircled. The file is created in the current directory.
An Undo mark is established by the application before changes are made. The user should be
able to undo the changes the application has made with one UNDO BACK command.
The allowable variation points and angles data boxes are used as a fuzz factor in the
equal command to compare points and angles on the lines. It is a real number defining the
maximum amount by which expr1 and expr2 can differ and still be considered equal.
This application is for use in Autocad 2000 and up.
Screen Shot:
As you can see, this program can dramatically decrease your file size.
Screen Shot of the "Mark with an ellipse " option:
Ordering Information:
To order this program please click the button above and pay $15.00 USD.
Please specify what the payment is for and your email address. Upon verification of
payment the program will be emailed to you. Or if you prefer, send a check or money
order made out to John Leavines to :
Jeffery P Sanders
PO Box 512
Tioga, LA 71477.
If you have any questions about the program click here.
Back to top
AutoLisp Home
Home
All questions/complaints/suggestions should be sent to /
Last Updated April 1st, 2013
Copyright 2002-2013 /. All rights reserved. |
